--- In "cottojavier" <> wrote:
>
> Hi, I have a TS-7200
>
> And, I have a serious problem when connect the AC power...
>
> I can not communicate by COM 1 to a ANSI Terminal using a null modem
> cable. (Jumper 2, 115200, etc...)
>
> I can not communicate by COM 2. (Jumper 2 and 4, 115200, etc...)
Hi --
Do you see any output from RedBoot or linux kernel during boot?
Please make sure you turn off all flow control on your terminal. (Do
not use HW or SW flow control).
>
> If I can ping the IP from the console (Port ethernet,using crossover
> cable),but,
> can not do telnet, can not do ftp.
Did you try ssh? Perhaps someone turned off telnet service for
security, and enabled ssh instead. If not, then you must log on using
the terminal and turn on the telnet service again.
>
> As checking the hardware and revise this good???
> What can I do?
You can find TS linux documents at:
http://www.embeddedarm.com/Manuals/gs_arm_tslinux.pdf
http://www.embeddedarm.com/Manuals/linuxarm-guide-rev2.3.pdf
>
> Thank everyone for the help
>
Regards, .......... Charlie
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|