Hi, Thankyou Charlie for you Answer, and sorry for writing so late.
Is good, turn on the telnet service and turn on ftp service, but can
not communicate by COM 1.
I check the option (turn off all flow control on terminal and not use
HW or SW flow control).
Also check with another TS7200 and very good.
(Disculpen mi ingles es muy malo, Gracias).
--- In "charliem_1216" <>
wrote:
>
> --- In "cottojavier" <cottojavier@> wrote:
> >
> > Hi, I have a TS-7200
> >
> > And, I have a serious problem when connect the AC power...
> >
> > I can not communicate by COM 1 to a ANSI Terminal using a null
modem
> > cable. (Jumper 2, 115200, etc...)
> >
> > I can not communicate by COM 2. (Jumper 2 and 4, 115200, etc...)
>
> Hi --
>
> Do you see any output from RedBoot or linux kernel during boot?
>
> Please make sure you turn off all flow control on your terminal.
(Do
> not use HW or SW flow control).
>
> >
> > If I can ping the IP from the console (Port ethernet,using
crossover
> > cable),but,
> > can not do telnet, can not do ftp.
>
> Did you try ssh? Perhaps someone turned off telnet service for
> security, and enabled ssh instead. If not, then you must log on
using
> the terminal and turn on the telnet service again.
>
> >
> > As checking the hardware and revise this good???
> > What can I do?
>
> You can find TS linux documents at:
> http://www.embeddedarm.com/Manuals/gs_arm_tslinux.pdf
> http://www.embeddedarm.com/Manuals/linuxarm-guide-rev2.3.pdf
>
> >
> > Thank everyone for the help
> >
>
> Regards, .......... Charlie
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|