No sign of /dev/ttts0. I've set it up to boot direct to the SD card,
so I put both tsuart1.ko and tsuart7800.ko on the initrd partition,
under the root directory, no luck. Tried putting only tsuart7800.ko,
and I've got nothing.... thoughts?
--- In "Michael" <> wrote:
>
> > Hi Mike,
> >
> > Before and after updating the driver, I'm only seeing 8 devices...
> > /dev/ttts1 through /dev/ttts8. At this point I'm just trying to
> > minicom on /dev/ttts4 to a standard serial port on my PC. I'm getting
> > a minicom: cannot open /dev/ttts4: No such device or address.
Thoughts?
>
> Do you see a /dev/ttts0? There was a typo bug that was fixed on Jan 21
> which caused the driver to only initialize 9 out of the 10 ports.
You may
> need to check the location you are installing the tsuart7800.ko
driver to...
> IIRC it should go in the root directory of the initrd (if you are
copying it
> from the fastboot prompt you need to use the 'save' command to
update the
> ramdisk image on flash).
>
>
> ______ Best Regards,
> |__ __/ Michael Schmidt
> || Software Engineer
> ||echnologic Systems (EmbeddedARM.com)
> || (480) 16610 East Laser Drive #10
> |/ 837-5200 Fountain Hills, AZ 85268
> http://oz.embeddedarm.com/~michael
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|