--- In "Michael Schmidt" <> wrote:
>
>
> On Mon, January 14, 2008 9:18 am, Rob wrote:
> > --- In "Rob" <rafferty29@> wrote:
> >>
> >> I start the board with the CF card installed and hit <control>c to
> > enter redboot. In redboot I
> >> enter:
> >> fis load vmlinux
> >> then
> >> exec -c "console=ttyAM0, 115200 root=/dev/hda1"
> >>
> >> I believe I am picking up the kernel on the flash rather than the
> >> one in Debian but am unsure how or why.
>
> "fis load vmlinux" is telling redboot to load the kernel from the
on-board
> flash. You will need to replace this command with a command to load the
> kernel from the CF card.
>
>
> ______ Best Regards,
> |__ __/ Michael Schmidt
> || Software Engineer
> ||echnologic Systems (EmbeddedARM.com)
> || (480) 16610 East Laser Drive #10
> |/ 837-5200 Fountain Hills, AZ 85268
> http://oz.embeddedarm.com/~michael
>
Thanks I thought that is what it might be but I was following TS
documentation. Does anyone have an example for a CF card running
Sarge? Any build will be fine as I can translate once I have a
sample. Also I am hoping to actually run from the CF if I wasn't
clear rather than load that into flash.
Thanks for the help so far.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|