--- In "Rob" <> wrote:
>
> I start the board with the CF card installed and hit <control>c to
enter redboot. In redboot I
> enter:
> fis load vmlinux
> then
> exec -c "console=ttyAM0, 115200 root=/dev/hda1"
>
> I believe I am picking up the kernel on the flash rather than the
one in Debian but am unsure
> how or why.
> >
> > How are you booting? It sounds like you are picking up an old kernel
> > version? What does dmesg say about the booted kernel version?
> >
> > Could you try to load the kernel by tftp or http? give it a new
> > filename, so you are sure you are getting the file you think you are
> > (my_real_ts11_kernel).
> >
> > Regards, ......... Charlie
> >
>
The first line on startup is:
Using base address 0x00218000 and length 0xDLinux version
2.4.26-vrs1-cirrus-1-2-1-ts8
This would seem to be the flash memory location. So how is the kernel
on the CF card accessed? Per the manual I did the two commands (fis
load / exec) but it is like there is a third needed???? Or do I need
to update flash somehow? I am stuck.
thanks
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|