On Mon, December 17, 2007 3:02 am, wizwally wrote:
> --- In "Michael Schmidt" <> wrote:
>>
>>
>> On Thu, December 6, 2007 4:14 am, wizwally wrote:
>> > Now that I downloaded the new driver, I tried to load it wityhout
>> > success. I got this error in dmesg log: "TS-UART/RF2 did not detect a
>> > TS-RF2 board. The 7800 board was shipped with the TS-RF2 and TS-GSM
>> > already connected.
>>
>> Can you try it with just the TS-RF2-Zigbee board connected and see
> if you
>> get the same result?
>>
>> Also, what jumper settings are you using on both board
>
> I tried with just TS-RF2 but tsuart-rf.ko won't load.
> The setting on the zigbee board are JP1 off, JP2 off, JP3 on, JP4 off
> On the GSM board are IRQ7 ON, JP1 OFF, JP2 OFF, JP3 OFF, JP4 OFF, JP5 ON
It looks like to me that there is a problem with the firmware on the
board, which will necessitate returning the board to have the problem
fixed. Laura can provide you with the RMA# which you will need.
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|