ts-7000
[Top] [All Lists]

Re: [ts-7000] Mechanical drawing error?

To:
Subject: Re: [ts-7000] Mechanical drawing error?
From: Eddie Dawydiuk <>
Date: Wed, 23 May 2007 08:30:22 -0700 (MST)
Hello,

> Perhaps, while you're at it, is the connector for the built-in ADC missing
> from the schematic? I can't seem to find it. (although it's not very
> exciting, and well documented elsewhere)

On page 28 of the TS-7250 manual there is a pinout and some information
on this header.

http://www.embeddedarm.com/Manuals/ts-7250-manual-rev2.2.pdf

-- 
Best Regards,
______________________________________________________________
  Eddie Dawydiuk, Technologic Systems | voice:  (480) 837-5200
  16610 East Laser Drive Suite 10     | fax:    (480) 837-5300
  Fountain Hills, AZ 85268            | web: www.embeddedARM.com

> On 5/21/07, Eddie Dawydiuk <> wrote:
>>
>>   Hello,
>> 
>> > I have a TS7250 and I'm currently studying the following documents that
>> > I believe are contradicting each other:
>> > http://www.embeddedarm.com/images/725stcllw.jpg
>> > http://www.embeddedarm.com/downloads/Schem_Mech/ts-7250_schematic.pdf
>> > http://www.embeddedarm.com/downloads/Schem_Mech/TS-7250_Mech.pdf
>> >
>> >
>> > For example:
>> > In the schematic U24 is the MAX197 chip and in the mechanical drawing
>> > combined with the picture U24 seems to be SDRAM (K4S561632E was SDRAM
>> > last i checked). The SDRAM is instead labeled U13 in the schematic.
>> >
>> > Any ideas?
>> 
>> You are correct, U24 is the SDRAM. I'll forward this to one of our
>> hardware engineers to see if we can release a revised schematic.
>> 
>> --
>> Best Regards,
>> __________________________________________________________
>> Eddie Dawydiuk, Technologic Systems | voice: (480) 837-5200
>> 16610 East Laser Drive Suite 10 | fax: (480) 837-5300
>> Fountain Hills, AZ 85268 | web: www.embeddedARM.com
>> 
>
>
>
>




 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 

<Prev in Thread] Current Thread [Next in Thread>
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU