Hello,
>> I noticed I was setting the wrong bit on the TS-7400 control
>> register. Doing a peek8 on the control register looks good now:
>>
>> :eeapnode# peek8 0x12000000
>> 0x2
>>
>> Here's my updated kernel module code:
>> http://cs.earlham.edu/~eeap/cvsweb/cvsweb.cgi/eeapnode/module/
>> eeapnode.c?rev=1.2
>>
>> But, I'm still failing to receive any interrupts on DIO 11. /proc/
>> interrupts and /proc/stat never record interrupts on IRQ 33.
>>
>> Hey, I forgot to thank you Eddie in my last message, but your pointer
>> to the end of the documentation was a big help.
>
> I am also seeing this same problem, did you ever find a resolution?
There was a problem discovered with the firmware on the TS-7400 with
regard to DIO_11 not properly generating interrupts when it was
configured as an external IRQ. A new revision of the firmware was
released on May 10 that resolves this issue. Please contact me off list
and I can get you an RMA to return your board to be reprogrammed as the
firmware is not field upgradable.
--
Best Regards,
______________________________________________________________
Eddie Dawydiuk, Technologic Systems | voice: (480) 837-5200
16610 East Laser Drive Suite 10 | fax: (480) 837-5300
Fountain Hills, AZ 85268 | web: www.embeddedARM.com
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|