Eddie,
I've done some further testing on this issue. I've modified the bat3
sources to let bat3 do some logging to syslog and started syslog
remote. Bat3 logs every second and the last message reported 3.28V:
Supply Voltage ADC | Regulated Voltage ADC | Battery Voltage |
1023.00 | 1023.00 | 3.28V |
Battery Current | TEMP | PWM T | PWM LO |
-750790mA | 26.9C | 01F4 | 0.00 |
PWM 1 EN | PWM 2 EN | OFFSET EN | OPAMP EN | BUCK EN | LED |
ON | ON | OFF | ON | OFF | OFF |
JP3 | Running on | softJP3 | locked | dVdT |
OFF | BATTERY | ON | OFF | 0.00 |
It's below the threshold voltage you reported earlier (3.4V) and at
this moment I didn't found any option to change that setting. After
putting back the power, the system starts but when we remove the power
again, it fails if we don't use het ISP-header. Is there a way to do
this reset by software?
This is the way I currently start bat3:
bat3 --on 300 --off 10 --charge 400
Greetings,
wimpunk.
--- In Eddie Dawydiuk <> wrote:
>
> Hello,
>
> > So the low power mode is entered when below the threshold voltage?
>
> Correct.
>
> //Eddie
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|