--- In "Michael Schmidt" <> wrote:
>
> > Hi,
> >
> > We're trying to control the TS-BAT3 using the bat3 program but we
> > don't get a proper result. It looks like the batteries are charging
> > but when we remove the power, the system halts almost immediatly.
> > We're using this command:
> >
> > bat3 --on 300 --off 10 --shutdown 30 --pwm1 1 --pwm2 1 --charge 400 &
> >
> > Any suggestions on what we do wrong?
> >
> > greetings,
> >
> > wimpunk.
> >
>
> Just FYI, the "--pwm1" and "--pwm2" options are ignored when
specifying the
> "--charge" options. The bat3 program will daemonize and
automatically turn
> the PWM circuits on and off as needed.
Thanks for the info.
>
> It looks like you've set the BAT3 board up to automatically shut
power off
> 30 seconds after power is removed. I assume this is what you
wanted? You
> might try leaving this statement out and see if that affects anything.
That was what we tried to do but the ts halts immediatly after
removing the power.
>
> Also, what is the behavior of the green LED? For the above
parameters you
> should see it flashing for 300 seconds, and then go off for 10 seconds.
>
That's correct, that's what the led does.
> How long are you letting the battery charge before removing the power?
A whole night. After removing the power , there was still almost 1.5V
on each battery.
wimpunk.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|