--- In Eddie Dawydiuk <> wrote:
>
> Hello,
>
> > I can't believe both systems are broken
>
> Keep in mind it may be a problem with your TS-7260 also.
We have three TS-7260 and three TS-BAT3 boards. At this moment I've
tested two pairs of them with the 0x0 result. Both TS-7260 boards
works correctly with the TS-SER4 but not with the TS-BAT3.
Normally I'll get my hands on the third one tomorrow (CEST) so I hope
that combination will work.
>
> > so let me give a little
> > overview before I send the systems back:
> > * TS-7260 with 2.4.26-ts11 pre-installed
> > * using COM2 as console
> > * On TS-7260 we have next jumpers enabled: JP2, JP3, JP4, JP7, JP9
> > * nothing connected besides network cable and serial cable
> > * TS-BAT3 plugged in
> > * only JP5 is enabled on TS-BAT3
> > * 24V supplied on square connector
> > On both systems I first tried the modules send by Eddie. Second I've
> > tried the peek8 command which gave me both the 0x0 result.
> > If I get the confirmation this system should work, we'll take the
> > necessary steps to send the systems back.
>
> This should work fine. I've verified it.
>
> //Eddie
>
So we will send them back.
wimpunk.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|