Hello,
> OK, ill go and read ts7300fb.o but how do you go about swapping to
> the other screens? im opening the (FB via a /dev/mem handle)
Take a look at the TS-7KV manual, on page 2 you will see the register
map and at the top of page 3 is an explanation of how to use the
window register.
http://www.embeddedarm.com/Manuals/gs_7kv.pdf
//Eddie
> --- In "PeterElliot" <> wrote:
>>
>> Hi Matt,
>>
>> I managed to switch off the screen blanking on my TS-7300 by
>> modifying the video module ts7300fb.o? the source is on the
>> technologic website (linux24/drivers/video/...). I simply commented
>> out the line which switched off the sync pulses... My screen now
>> stays permenently on and I can switch it off from software as
> needed.
>>
>
>
>> I haven't switched off the console or the blinking cursor, but
>> noticed that it is only displayed on the first screen page. As you
>> have 8 screen buffers to play with just use another page in the
>> screen buffer and the cursor goes away. Switching to the original
>> page brings it back.
>>
>> Hope this helps, it was a while ago that I did the driver mod.
>>
>> Regards,
>>
>> PJE
>>
>> --- In "mattsaintdev" <mattsaintdev@>
>> wrote:
>>>
>>> Following on from my howto not flash the cursor. Where is the
>> blanking
>>> enabled / disabled from. The TS7200 switches off TS 7KV screen
>> output
>>> after a few mins.
>>>
>>> Matt
>>>
>>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|