| To: | |
|---|---|
| Subject: | [ts-7000] USB serial reset |
| From: | Philip Heron <> |
| Date: | Fri, 10 Jun 2005 17:11:52 +0100 |
Hi all, I've got a new USB GPS receiver which is causing problems on my TS-7200. The receiver works perfectly on my big machine, however when I plug it into the TS-7200 the board will reboot itself. Once it comes back up the GPS receiver is present and works. Has anyone else seen this? I can't think of any reason other than a power spike, but it's only rated at 5V + 90mA. Later, -Phil <>
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [ts-7000] Re: serial port question, Jesse Off |
|---|---|
| Next by Date: | Re: [ts-7000] USB serial reset, Andy Warner |
| Previous by Thread: | [ts-7000] serial port question, Wouter van Wyk |
| Next by Thread: | Re: [ts-7000] USB serial reset, Andy Warner |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU
