Thanks,
finally it is working!!
(with a lot of tries with setserial)
MT
--- In "vocemanago" <> wrote:
>
> --- In "vocemanago" <>
wrote:
> >
> > In my serial.conf file I have...
> >
> > # These are the standard COM1 through COM4 devices
> > #
> > /dev/ttyS0 uart 16550A port 0x89C003F8 irq 40
> > /dev/ttyS1 uart 16550A port 0x89C002F8 irq 33
> > /dev/ttyS2 uart 16550A port 0x89C003E8 irq 40
> > /dev/ttyS3 uart 16550A port 0x89C002E8 irq 33
> >
> > This is using the development Flash card of course, in your case
you
> > would be using a development USB flash drive.
> >
> > T.
> I made a mistake somewhere. I started back through my emails with
> technologic. There was an update to the kernel, which I don't know
if
> you have or not and then the enumeration was backwards from above.
> /dev/ttyS0 is irq 33
> /dev/ttyS1 is irq 40
> /dev/ttyS2 is irq 33
> /dev/ttyS3 is irq 40
>
> I think,
> I went around in circles with this one, but finally got the board
to work.
> T.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|