hey Dalibor;
That's my thread at Quakefinder, I am glad that it helped! But I caution that
it has only been 'finished' up through a certain step. Once I get parallel
port working ;) I'll finish those howtos.
--- In "daliborfarny" <> wrote:
>
>
>
> --- In "Rekcut_Nod" <dtucker@> wrote:
> >
> > Has anyone managed to get this combination running? I tried to get this
> > image
> >
> > ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7260-linux/binaries/ts-images/512mbsd-7400-linux2629-lenny-eabi.dd.bz2
> >
> > to boot with a rebuilt kernel using this source
> >
> > ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7260-linux/sources/tskernel-2.6.29-ts-src.tar.gz
> >
> > and a config file that I used with a 2.6.21-ts kernel, but the the
> > resulting SD card just keeps rebooting after the second '.' following the
> > "TS-BOOT" message.
> >
> > I am only considering doing this because the 2.6.21-ts driver for the
> > TS-ETH2 card (ax88796b) seems to have issues. :(
> >
> > Don
> >
>
> Hello Don,
>
> I was not successful with images from embeddedarm.com, I tried different
> block sizes (bs parameter) on dd to make it work... Then I found that howto:
>
> http://www.quakefinder.com/smf/index.php?topic=103.0
>
> and there is a link on the image they made and that worked:
>
> http://www.quakefinder.com/smf/EQTdata/their2.6.dd
>
> I dd'd on the 4GB SDHC card with bs=2048 and it worked. It is 2.6.29-ts
> kernel. I needed some other kernel modules, so I recompile the kernel from
> the source on embeddedarm (2.6.29-ts) with slightly changed configuration and
> everything ok..
>
> Dalibor
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|