ts-7000
[Top] [All Lists]

[ts-7000] 2.6.34 on TS7300 without NFS - what am I doing wrong?

To: <>
Subject: [ts-7000] 2.6.34 on TS7300 without NFS - what am I doing wrong?
From: Ian Thompson <>
Date: Tue, 12 Oct 2010 10:52:33 -0500
Andrew

There are a few "patches to the patches" required. I haven't checked
recently to see if they have worked their way back into the system.
Below is my boot list.

Ian T.


>> TS-SDBOOT - built Jul  6 2006
>> Copyright (c) 2006, Technologic Systems
.
.
.
Uncompressing Linux... done, booting the kernel.
Linux version 2.6.34-m1  (gcc version 4.3.2 (Debian
4.3.2-1            .1) ) #16 PREEMPT Wed Aug 18 08:28:01 MST 2010
CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=40007177
CPU: VIVT data cache, VIVT instruction cache
Machine: Technologic Systems TS-72xx SBC
Memory policy: ECC disabled, Data cache writeback
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 9040
Kernel command line: console=ttyAM0,115200 root=/dev/ram0 rw init=/linuxrc
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 8MB 8MB 8MB 8MB 8MB 8MB 8MB 8MB = 64MB total
Memory: 57496k/57496k available, 8040k reserved, 0K highmem
Virtual kernel memory layout:
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
    fixmap  : 0xfff00000 - 0xfffe0000   ( 896 kB)
    DMA     : 0xffc00000 - 0xffe00000   (   2 MB)
    vmalloc : 0xce000000 - 0xfe800000   ( 776 MB)
    lowmem  : 0xc0000000 - 0xcd800000   ( 216 MB)
    modules : 0xbf000000 - 0xc0000000   (  16 MB)
      .init : 0xc0008000 - 0xc0022000   ( 104 kB)
      .text : 0xc0022000 - 0xc02e3000   (2820 kB)
      .data : 0xc02f8000 - 0xc0317860   ( 127 kB)
Hierarchical RCU implementation.
NR_IRQS:120
VIC @fefb0000: id 0x00041190, vendor 0x41
VIC @fefc0000: id 0x00041190, vendor 0x41
Console: colour dummy device 80x30
Calibrating delay loop... 99.73 BogoMIPS (lpj=498688)
Security Framework initialized
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
ep93xx clock: PLL1 running at 400 MHz, PLL2 at 192 MHz
ep93xx clock: FCLK 200 MHz, HCLK 100 MHz, PCLK 50 MHz
ep93xx dma_m2p: M2P DMA subsystem initialized
ep93xx dma_m2m: M2M DMA subsystem initialized
bio: create slab <bio-0> at 0
SCSI subsystem initialized
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
Trying to unpack rootfs image as initramfs...
rootfs image is not initramfs (junk in compressed archive); looks like
an initrd
Freeing initrd memory: 4096K
NetWinder Floating Point Emulator V0.97 (double precision)
JFS: nTxBlock = 481, nTxLock = 3849
msgmni has been set to 120
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
Serial: AMBA driver
apb:uart1: ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA
console [ttyAM0] enabled
apb:uart2: ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA
apb:uart3: ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA
brd: module loaded
No NAND device found.
ep93xx_mii_bus: probed
ep93xx_eth:ep93xx_mii_probe: PHY supports MII frame preamble suppression
ep93xx_eth:ep93xx_mii_probe: attached PHY driver [Generic PHY]
(mii_bus:phy_addr            =0:01, irq=-1)
net eth0: ep93xx on-chip ethernet, IRQ 39, 00:d0:69:41:51:cb
ep93xx-rtc ep93xx-rtc: rtc core: registered ep93xx-rtc as rtc0
rtc-m48t86 rtc-m48t86: rtc core: registered m48t86 as rtc1
rtc-m48t86 rtc-m48t86: battery ok
ts72xx-wdt ts72xx-wdt: TS-72xx Watchdog driver
TCP cubic registered
NET: Registered protocol family 17
rtc-m48t86 rtc-m48t86: setting system clock to 2010-10-12 15:47:26 UTC
(12868984            46)
RAMDISK: ext2 filesystem found at block 0
RAMDISK: Loading 1536KiB [1 disk] into ram disk... done.
EXT2-fs (ram0): warning: mounting unchecked fs, running e2fsck is
recommended
VFS: Mounted root (ext2 filesystem) on device 1:0.
Freeing init memory: 104K
>> Booting to SD Card...
ts72xx-sdcard ts72xx-sdcard.0: SD card hardware revision: 00000000
ts72xx-sdcard ts72xx-sdcard.0: block device major number = 254
ts72xx-sdcard ts72xx-sdcard.0: New SD card detected, name=tssdcarda
size=990976             (sectors)
 tssdcarda: tssdcarda1 tssdcarda2 tssdcarda3 tssdcarda4
jfs: Unrecognized mount option "relatime"  or missing value
Mount failed for selinuxfs on /selinux:  No such file or directory
INIT: version 2.86 booting


This e-mail, including any attachments and response string, may contain 
proprietary information which is confidential and may be legally privileged. It 
is for the intended recipient only. If you are not the intended recipient or 
transmission error has misdirected this e-mail, please notify the author by 
return e-mail and delete this message and any attachment immediately. If you 
are not the intended recipient you must not use, disclose, distribute, forward, 
copy, print or rely on this e-mail in any way except as permitted by the author.


------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

<Prev in Thread] Current Thread [Next in Thread>
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU