It appears that I actually have a 2.6.34 kernel up and running on the 7350.
I'm not sure if the thing is totally right. If anyone has suggestions on a
validation procedure, please share.
I started with Matthieu's patches. This builds fine under a Crosstool-NG
toolchain on a Debian system running under Parallels on a Mac. (I would like
some Parmesan with my spaghetti code though).
The 7350 has a couple of specific drivers that needed a refresh. The tsuart
and xuart stuff need some minor semantic modifications. The ts72xx files need
additions for the 7350's addresses and such.
The SD card driver is a little tricky since it appears to be intended as a
built-in rather than a module for the 72xx boards. I haven't gotten it to work
as a built-in but I did get it to work as a module. This doesn't appear to be
a problem since the FPGA has code to load the kernel off the SD card.
I also needed to configure the kernel for built-in RAM disk/initrd support and
change the boot string to use that instead of NFS.
The kernel images are also too big for the stock partitioning. I already had a
slightly larger one but it will only fit the zImage.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|