Satish,
Thanks for help. You are correct. Removing jumper J2 solved the problem.
Just FYI, I am using Micro-50-D45 inclinometer (tilt sensor) from
SpectronSensors.com
- Alex
--- In Satish Chetty <> wrote:
>
> Alex,
> COM1 is used as your console. I remember reading in 7260 manual that
> you need to set some jumpers if you want to use COM1 as a regular COM
> instead of console.
>
> What tilt sensor are you using?
>
> -Satish.
>
> On 03/24/2010 12:30 PM, Alex wrote:
> >
> >
> > I have a TS-7260 that suppose to read data from tilt sensor over RS-232.
> > The COM2 on TS7260 is already used for different purposes. So my choices
> > are either to use COM1 or COM3. I am trying to use COM1, and everything
> > works fine as long as I plug in tilt sensor into COM1 after TS7260
> > booted up. However TS-7260 would not boot up with tilt sensor connected
> > on COM1. Did anybody ran into similar problem with COM1? Any ideas how
> > to solve it? If not, can somebody help me how to activate and access
> > COM3 on TS7260?
> >
> > - Alex
> >
> >
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|