Alex,
COM1 is used as your console. I remember reading in 7260 manual that
you need to set some jumpers if you want to use COM1 as a regular COM
instead of console.
What tilt sensor are you using?
-Satish.
On 03/24/2010 12:30 PM, Alex wrote:
>
>
> I have a TS-7260 that suppose to read data from tilt sensor over RS-232.
> The COM2 on TS7260 is already used for different purposes. So my choices
> are either to use COM1 or COM3. I am trying to use COM1, and everything
> works fine as long as I plug in tilt sensor into COM1 after TS7260
> booted up. However TS-7260 would not boot up with tilt sensor connected
> on COM1. Did anybody ran into similar problem with COM1? Any ideas how
> to solve it? If not, can somebody help me how to activate and access
> COM3 on TS7260?
>
> - Alex
>
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|