Re: [ts-7000] Connect with CMUCAM

[Muchammad Fachri <>]

i have checked it on minicom and set it to 115200 8N1, FYI it wont works if i use another speed, but if i use 115200 8N1, it only appears that strange character, or maybe i should set baud rate by ts-7800 itself (maybe need editing at some driver/register or make a c source code?)

2010/3/11 Alexey Vdovin <>

 

Fachri,

On Thu, Mar 11, 2010 at 10:42 AM, fahri_4265 <> wrote:

 

I try to connect my TS-7800 board to CMUCAM by installing minicom on my TS-7800 and connect the cam using COM3 serial port after that, i try to communicate the TS-7800 board from my laptop to the board by telnet and then open minicom application at my board

usually if i connect the CMUCAM direct to my PC with minicom at my PC there is a message appear like this :

CMUcam2 v1.00 c6
:

but if i use TS-7800's minicom it just appearing strange character like this

N....&#65533;.&#65533;&#65533;&#65533;K.&#65533;&#65533;&#65533;

i already set the TS-7800'S minicom to read COM3 port ( /dev/ttts4/ ) if i type something it respond but the respond is not the standard respon that usually appear if i connect the cam direct to my PC

do you can get me some solution?

Check baud rate setting on COM3.

---
BR
Alexey

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___