ts-7000
[Top] [All Lists]

[ts-7000] Need Bitmap to Hex converter

To:
Subject: [ts-7000] Need Bitmap to Hex converter
From: Milind Pande <>
Date: Sun, 21 Feb 2010 22:40:57 -0800 (PST)



Dear Derek,
 
 Please provide us the Bitmap to Hex converter.
 
Regards,
Milind

From: Derek <>
To:
Sent: Sun, February 21, 2010 4:00:44 AM
Subject: [ts-7000] Re: TS7260 - Debian GCC error

 

On a Linux development PC, insert the SD card into the SD card reader and then into the USB port on your PC. Then, use the dmesg | tail command or the fdisk -l command to find out what device node Linux assigned to your SD card. Usually it's /dev/sdb. Then, the following commands should get you there (assuming it's a typical 4 partition SD card from TS)...

# create a mount directory
mkdir /mnt/sdcard

# mount the last partition to the directory created above
mount /dev/sdb4 /mnt/sdcard

# remove all files in the partition
rm -rf /mnt/sdcard/ *

# download the filesystem from the FTP site
wget ftp://ftp.embeddeda rm.com/ts- arm-sbc/ts- 7260-linux/ distributions/ debian-sarge- 256MB-05- 01-2006.tar. bz2

# extract the filesystem to the last partition
tar xvf debian-sarge- 256MB-05- 01-2006.tar. bz2 -C /mnt/sdcard/

# umount the drive
umount /dev/sdb4

You should be done at this point. Plug it into the TS-7260 and try to boot to full Debian.

-Derek

--- In ts-7000%40yahoogroups.com, "tsao.terence" <tsao.terence@ ...> wrote:
>
> Hi Derek,
>
> Can you give me the instruction of reinstalling the filesystem on the last partition. Or Should I call you later for it?
>
> thanks!
>
> --- In .com, "Derek" <derek@> wrote:
> >
> > --- In .com, "tsao.terence" <tsao.terence@ > wrote:
> > >
> > > Dear GCC masters,
> > >
> > > I created hello.c in TS7260 (booting Debian from SD), and when I compiled with the following: "gcc-3.3 hello.c"
> > >
> > > I got the following error:
> > >
> > > gcc-3.3: installation problem, cannot exec `cc1': No such file or directory
> > >
> > > Has anyone encountered this problem before?
> > >
> >
> > I spoke with a customer over the phone yesterday about this issue on this board (I wouldn't be surprised if it was you!). I tested this on a factory SD card image and it works fine. I recommend either re-installing the filesystem on the last partition or simply re-imaging the SD card with image available on FTP site.
> >
> > Best Regards,
> >
> > Derek Hildreth
> > ------------ --------- --------- ------
> > Embedded Systems Engineer
> > Technologic Systems
> > 480.837.5200
> > ------------ --------- --------- ------
> >
>




__._,_.___


Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___
<Prev in Thread] Current Thread [Next in Thread>
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU