I don't know how many times, I have to post this.
"512mbsd-7400- linux2629- lenny-eabi. dd" works on the TS-7300.
It is found at ...
ftp://ftp.embeddeda rm.com/ts- arm-sbc/ts- 7400-linux/ binaries/ ts-images/
It provides a 2.6.29 kernel and a Lenny eabi distribution.
I don't run X, so I don't know how well it supports X.
Ian T.
--- In .com, "rchertov" < .> wrote:
>
> Hello,
>
> I have ported 2.6.29-ts onto TS-7300 and actually managed to boot it off the flash card. However, there are still two issues that I am facing. First, 64megs of RAM (128MB total) are ignored.
>
> Machine: Technologic Systems TS-72xx SBC
>
> NR_BANKS too low, ignoring memory at 0xe0000000
> NR_BANKS too low, ignoring memory at 0xe1000000
> NR_BANKS too low, ignoring memory at 0xe2000000
> NR_BANKS too low, ignoring memory at 0xe3000000
> NR_BANKS too low, ignoring memory at 0xe4000000
> NR_BANKS too low, ignoring memory at 0xe5000000
> NR_BANKS too low, ignoring memory at 0xe6000000
> NR_BANKS too low, ignoring memory at 0xe7000000
> Memory policy: ECC disabled, Data cache writeback
> On node 0 totalpages: 16384
>
>
> Second, I have problems with serial login. I can see the login prompt over serial, but I cannot type anything. When I run 'echo "test" > /dev/ttyAM0' on the board, I see the output on the cu terminal of the host computer. (I can SSH into the board to run the commands). If I type a bunch of characters into the serial terminal and then reboot the board, I will see them appear on the fastboot prompt. It is as if the data is not pulled from the host computer and just sits there in the buffer.
>
> I have also tried 2.6.21-ts that TS provides along with their nfs_root debian image. I get the same problem. I also checked that the ttyAM0 is present in /etc/securetty.
>
> If I use the default 2.4 image, then everything works fine. Except for the case, when there is a second SD card plugged in. Then I experience the same problem. I am curious if anybody experienced this, and how they solved this.
>
> Thanks
>