[ts-7000] Board I/O

To:
Subject:	[ts-7000] Board I/O
From:	"ts7300" <>
Date:	Tue, 18 Aug 2009 07:31:06 -0000

Hi,
   I am using TS-7300 board In Project I supposed to run hooter(alarm siren) 
using Board I/O.Can I use DI0 HEADER for that.In manual mention DIO first 
HEADER pin-20 is at +5V.Will it work or not?? 



------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

<Prev in Thread]	Current Thread	[Next in Thread>
[ts-7000] Board I/O, ts7300 <=

Previous by Date:	[ts-7000] X11 config file, Mike Lehmann
Next by Date:	[ts-7000] Re: where's the source?, j.chitte
Previous by Thread:	[ts-7000] X11 config file, Mike Lehmann
Next by Thread:	[ts-7000] problem Read Only for TS-7390, tonpi_487
Indexes:	[Date] [Thread] [Top] [All Lists]

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU