[ts-7000] pppd versus AT commands

To:	TS-7300 <>
Subject:	[ts-7000] pppd versus AT commands
From:	pierrot lafouine <>
Date:	Mon, 1 Jun 2009 09:39:50 -0400

Hi
I have setup a pppd for the TS-GSM1.
Is it possible to send a specific AT command thru this pppd ?
Let say I want to have the signal strength of the TS-GSM1 after pppd is setup
Is there anyway to send AT command AT+CSQ ?

Thanks

Pierre

You take the blue pill, the story ends, you wake up in your bed, and believe whatever you want to believe.
You take the red pill, you stay in Wonderland, and I show you just how deep the rabbit hole goes
Morpheus

Internet Explorer 8 makes surfing easier. Get it now!

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___

<Prev in Thread]	Current Thread	[Next in Thread>
[ts-7000] pppd versus AT commands, pierrot lafouine <=

Previous by Date:	[ts-7000] Re: 7800 & 3rd party A2D, Anouk Ahamitet
Next by Date:	[ts-7000] cannot find inittab, and can't figure out how to bypass, pattykirsch
Previous by Thread:	[ts-7000] Re: 7800 & 3rd party A2D, Anouk Ahamitet
Next by Thread:	[ts-7000] cannot find inittab, and can't figure out how to bypass, pattykirsch
Indexes:	[Date] [Thread] [Top] [All Lists]

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU