oops,
just check the current /etc/init.d/rc.local to see if it has any
reference to /etc/rc.local. If yes put your stuff in /etc/rc.local.
ex: vi /etc/rc.local
#! /bin/sh
/sbin/insmod /usr/lincan/modules/lincan-ts11.o hw-tscan1 baudrate=500
Daniel
--- In "danjperron" <> wrote:
>
> just add your command into rc.local
>
>
> For a debian system it will be
> /etc/init.d/rc.local
>
> or in TS linux it will be
> /etc/rc.d/rc.local
>
>
> just add your command into /etc/init.d/rc.local
>
> Daniel
>
>
>
> --- In "bwa4992" <bwa4992@> wrote:
> >
> > I have a TS-7260 board with a TS-CAN1 daughterboard on the PC-104 bus.
> > I am running the full Debian system (2.4.26-ts-11) from an SD card in
> > the TS-7260.
> >
> > I can successfully load the lincan driver from the console prompt
with:
> >
> > # cd /usr/lincan/modules
> > # insmod lincan-ts11.o hw-tscan1 baudrate=500
> >
> > But I would like to have the system load the driver at boot time, and
> > I haven't found a way to make this happen.
> >
> > I've tried a couple of methods including modifying the /etc/modules
> > file directly, and using modconf to set up the driver at boot time,
> > but nothing has worked so far.
> >
> > Has anyone been able to get the lincan driver to load at boot time?
> > What steps did you take?
> >
> > Thanks,
> >
> > Ben
> >
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|