Re: [ts-7000] Relay boards at 5V

["Eric Robishaw" <>]

How about using the EmbeddedArm TS12 powersupply ($38) which takes 12-38VDC.  Thus you can use the same 12V for your relay board and the TS7800 through this power adapter.

Eric

On Wed, Oct 29, 2008 at 12:48 PM, Jason Stahls <> wrote:

Yan Seiner wrote:
> Does anyone have a source for an 8 channel relay board that works on
> 5V? I've found lots of 12V relay boards like this one:
>
> <http://robokitsworld.com/index.php?main_page=product_info&products_id=213>
>
> but I'd rather not be dealing with 2 power supplies.... I need
> something that's powered from the same 5V as the TS boards, and that
> can use the 3.3V output from the DIO header on the mainboard.
>
> I know I can build one, but this is for a 1-off project, so I'd rather
> buy off-the-shelf if I can....

I have some one-off i2c boards that I could give you but their not relay
output.. How much current are you requiring? These are 24 or 32 (can't
remember) 5v I/O and spaced to stack ontop of the TS-7200

Jason Stahls

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___