Re: [ts-7000] Re: IPv6 on TS-7400 : Howto?

[Pradip De <>]

Thanks Jim for your help though. I will make a new post for this problem.
Pradip

----- Original Message ----
From: Jim Jackson <>
To:
Sent: Friday, September 19, 2008 3:02:15 AM
Subject: Re: [ts-7000] Re: IPv6 on TS-7400 : Howto?

On Thu, 18 Sep 2008, Pradip De wrote:

> I have finally managed to compile and generate a kernel image
> (uncompressed, as make zImage was throwing error). I also have the
> compiled modules. Whats the next step from here. Where do I put this new
> image and how do I get these new modules to be used by the TS7400. I
> tried putting the entire /lib/modules into the corresponding place in the
> TS7400. However, I dont know how to make the new kernel loadable. Any
> help is highly appreciated.

I have no experience with the ts7400, so cannot help.
On the ts7200, I configured redboot to load the kernel from that board's
CFDisk - that means I can revert to a known good kernel in the onboard
flash. I seem to remember that the ts7400 doesn't have redboot. I really
do not know what the boot arrangements. Can you configure the loader to
load the new kernel image via TFTP?

Maybe 7400 users can offer further assistance.

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___