On Thu, 18 Sep 2008, Pradip De wrote:
> I have finally managed to compile and generate a kernel image
> (uncompressed, as make zImage was throwing error). I also have the
> compiled modules. Whats the next step from here. Where do I put this new
> image and how do I get these new modules to be used by the TS7400. I
> tried putting the entire /lib/modules into the corresponding place in the
> TS7400. However, I dont know how to make the new kernel loadable. Any
> help is highly appreciated.
I have no experience with the ts7400, so cannot help.
On the ts7200, I configured redboot to load the kernel from that board's
CFDisk - that means I can revert to a known good kernel in the onboard
flash. I seem to remember that the ts7400 doesn't have redboot. I really
do not know what the boot arrangements. Can you configure the loader to
load the new kernel image via TFTP?
Maybe 7400 users can offer further assistance.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|