Re: [ts-7000] slip configuring problem on ts7800

[Paolo Marras <>]

Hi Frank,
Thanks
but it was already commented out.

any other ideas?

Paolo

----- Original Message ----
From: Frank <>
To:
Sent: Friday, September 12, 2008 2:55:01 PM
Subject: Re: [ts-7000] slip configuring problem on ts7800

By default, getty has a hold on the serial ports.  Make sure this line:

#T1:23:respawn: /sbin/getty -L ttyS1 115200 vt100

Is commented out in /etc/inittab and reboot (although I've heard a reboot is not necessary).

-Frank

nibapa wrote:

Hi everybody,

I have configured slip on my ts7800:

/sbin/slattach -p slip -s 19200 -L /dev/ttyS1 &
/sbin/ifconfig sl0 192.168.171 pointopoint 192.168.170 up

properly adding route, but ping to a linux fedora pc slip configured
doesn't run.

The same experiment runs without any problems between two linux fedora pc.

Did anyone try to configure slip with good results?

thanks in advance

Paolo

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___