--- In "gpimentel074" <> wrote:
> Hi, i'm trying to access the IO ports locate
> on 40 header-pin on board ts-7370. I'm tried
> using some rotines implemeneted on ts7000.subr
> to modify some pins state like DIO12 pin but
> without success.
> The command syntax is:
> dio_dir_set 12 1
> dio_data_set 12 1
> I'm using a multimeter to measure the output
> voltage between the DIO12 pin and GND signal.
Greetings, Gustavo
Could you post some actual code for us to look at? You set the
direction of a pin and you set the output value yet I don't see where
you ensured that the function of the pin is an I/O.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|