--- In Eddie Dawydiuk <> wrote:
>
> Hello,
>
> > We're recently testing the RS-485 functionality on the SER4 boards and
> > I'm running into trouble. While reading the documentation, I find:
> >
> > There is a control bit (See Section 5) that must be set for proper
> > RS-485 or RS-422
> > operation. This bit must be set once and does not need to be updated.
> > This enable bit
> > solves a problem when RTS is asserted during boot. The BIOS and some
> > Operating
> > Systems toggle RTS during boot, which could cause it to "jam" the
> > RS-485 bus.
> >
> > To set this bit, we need the base address but where can we find that
> > one? I was hoping to find a solution in readmeter.c which I found in
> > the example code but it didn't help me pretty much.
> >
> > Could someone help me?
>
> The TS-Ser4 shows up in I/O space. 8 bit I/O space starts at
> 0x11E0_0000, just add the offset you have the board jumpered for. You
> can find documentation on what the offsets are (based upon the jumpers)
> in the TS-Ser4 manual.
>
> http://www.embeddedarm.com/Manuals/TS-SER4.pdf
>
For those who are looking for this documentation: the current version
can be found on
http://www.embeddedarm.com/documentation/ts-ser4-manual.pdf
kind regards,
wimpunk.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|