ts-7000
[Top] [All Lists]

RE: [ts-7000] TS-7400 tsuart insmod fails

To: "" <>
Subject: RE: [ts-7000] TS-7400 tsuart insmod fails
From: Jayne Dickinson <>
Date: Thu, 26 Jun 2008 14:39:29 -0700
Thanks Michael...
This still doesn't answer the question, I need access to all 3 com port drivers 
so I can open  /dev/ttyAM0, /dev/ttyAM1, and /dev/ttyTS0 for my application.

I have disabled the getty by commenting the inittab lines where both ttyAM0 and 
ttyAM1 are enabled.
I need the tsuart.o since it creates the ttyTS0 driver...

Where can I find it on your web site...since the boot shows that it has 
failed....why is the insmod in the init.d
if it is unsafe to load this driver anyway?

Thanks for your help
Jayne

________________________________________
From:   On Behalf Of Michael 
Schmidt 
Sent: Thursday, June 26, 2008 2:28 PM
To: 
Subject: Re: [ts-7000] TS-7400 tsuart insmod fails

Jayne Dickinson wrote:
> Greetings,
>
> Where is the TS-7400 tsuart.o on the TS FTP site? I can
> only find tsuart0.o and tsuart7260.o on
> ftp://oz.embeddedarm.com/ts-arm-sbc/ts-7400-linux/binaries/ts-modules
> directory....

Last I checked TS-7400 TS-UART support was built into the kernel. This
is because some of the UART functionality on the TS-7400 must be
detected earlier in the boot process then is possible if loaded as a
module (e.g. console on the TS-7412), and there also is some interaction
with the Amba UARTs (flow control access through the same PLD I believe).

tsuart0.o is the core TS-UART module. For a kernel with this module
built in it is not safe to load this module.

--
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael



------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

<Prev in Thread] Current Thread [Next in Thread>
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU