> I've observed that state of DIO_14 is undetermined after power up. Is
> that easily fixable? I'd like if to be either input or output with a
> zero value. That's because I want to use that pin to enable power
> output just after I've reset output registers so I don't have outputs
> randomly activated after power up.
>
> Is that random state of DIO_14 a bug or a feature?
DIO_14 should be powering up as an input. If you try to read the value it
is going to look random, but since it is an input you aren't going to be
able to drive anything or sink any current.
> Thanks in advance
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|