how i can do this ?
You may need to run a command to make it show up (e.g.
mdev -s) if udev isn't running...)
how i can run udev ?
wich sintax ?
i ve loaded the two module tsuart1 and tsuart7800 and all ok if i
digit lsmod i se them i hope u write me back soon
--- In "Michael" <> wrote:
>
> > another question : com3 corrispond to ttyS2 ?
> > is active directly or i must load the module tsuart7800?
>
>
> http://oz.embeddedarm.com/~michael/support/ts7800.html#uart
>
> COM3 is TS-UART #4. After loading tsuart1 and tsuart7800 it should
show up
> at /dev/ttts4. (You may need to run a command to make it show up (e.g.
> mdev -s) if udev isn't running...)
>
> ______ Best Regards,
> |__ __/ Michael Schmidt
> || Software Engineer
> ||echnologic Systems (EmbeddedARM.com)
> || (480) 16610 East Laser Drive #10
> |/ 837-5200 Fountain Hills, AZ 85268
> http://oz.embeddedarm.com/~michael
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|