On Wed, January 2, 2008 1:09 pm, JD wrote:
> ok,
>
> Got a little confused previously when mknod /dev/ttyS3 was used for
> the first ts port, and made me think that perhaps the 3rd port was CPU
> based.
Well it is a little confusing because the first two TS-UARTs are actually
on the flow control pins for COM1 and 2. The third TS-UART is actually on
the normal COM3 pins.
>
> Is there a document that says which com port corresponds to which on
> the DB9 connectors (apart from the com1,2&3)?
This information is in the preliminary TS-7800 manual at
http://oz.embeddedarm.com/~michael/support/ts7800.html, under the "UARTs"
section.
> The comports info.txt file just says howmany there are, whilst the
> schematic shows the ppinds but named using the cts/rts name, but I
> didnt see any reference to say which was for which.
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|