[ts-7000] SNMP support

[Zombi process <>]

Anyone known where can Obtaining snmp support?

 

thanks

Michael Schmidt <> escribió:

On Tue, December 18, 2007 9:49 am, JD wrote:
> Hi all, it there any example code around for setting up and using the
> serial ports for the 7800?

Sample code for setting up termios in general:
ftp://ftp.embeddedARM.com/tmp/term.c

> I can access the 1st serial port and seem to be able to open the 2nd
> and 3rd, however it doesnt like me setting the baudrate etc - I am

What do you mean "it doesnt like"? What are the error messages you are
getting?

> guessing I dont have the syscon regs set up correctly for the port to
> be independant?
> Or should the serial driver automatically do that on opening the port?

The driver (tsuart7800) sets up the baud rate registers when it is loaded.
Any UART pins that override other pin meanings will do so when the UART
is enabled, which is while the device file for the port is open.

______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael

---

Yahoo! Encuentros
Ahora encontrar pareja es mucho más fácil, probá el nuevo Yahoo! Encuentros.
 Visitá http://yahoo.cupidovirtual.com/servlet/NewRegistration
__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___