I have two thoughts:
1. Did you put the SD Card in the correct slot (nearest the CPU) -
Right slot when looking at the back.
2. Is you're power supply providing sufficient power?
Regards,
Juan
--- In "Andy Mercier" <>
wrote:
>
> --- In "serdar_akkan" <serdar_akkan@>
wrote:
> >
> > hi all,
> >
> > when i turn on the power of 7300 board the green and red led
turns on
> > and then red led turns off after 3 or 4 seconds red led blinks
and i
> > think the board reset. if the power still on this is done again
and
> > again.
> >
> > is this a hardware problem or software problem?
> Yes. ;)
>
> Seriously, there's not enough information to tell yet. Your
> description shows that the TS-7300 is running it's firmware though.
>
> > how can i solve that problem?
> 1) Make sure the SD card is plugged in.
> 2) The SD card needs to have the operating system on it.
> 3) Make sure the SD card is in the slot that is inline with the
Cirrus
> Logic processor - not the one inline with the Altera FPGA.
>
> Andy
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|