--- In "serdar_akkan" <> wrote:
>
> hi all,
>
> when i turn on the power of 7300 board the green and red led turns on
> and then red led turns off after 3 or 4 seconds red led blinks and i
> think the board reset. if the power still on this is done again and
> again.
>
> is this a hardware problem or software problem?
Yes. ;)
Seriously, there's not enough information to tell yet. Your
description shows that the TS-7300 is running it's firmware though.
> how can i solve that problem?
1) Make sure the SD card is plugged in.
2) The SD card needs to have the operating system on it.
3) Make sure the SD card is in the slot that is inline with the Cirrus
Logic processor - not the one inline with the Altera FPGA.
Andy
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|