Set up 2 ts7000's to talk to each other with the same code you're using.
Then get them talking to each other, then work up to where you are working with
the unknown you have now.
From: Jason Stahls <>
Date: 2007/07/13 Fri PM 01:30:15 EST
To:
Subject: Re: [ts-7000] RS485 on TS-SER4
IMHO, check it with a scope, make sure the BlackBox isn't misconfigured.
Jason
wimpunk wrote:
> Hi Group,
>
> We're still having troubles talking RS485 on our TS-SER4 board. These
> are the step we took:
> * Set the jumper on RS-485
> * Set the bit in the register (see message #7467)
> * We connected RX/TX+ (pin1) and RX/TX- (pin6) to our blackbox
> RS232/RS485 convertor.
>
> We did several tries to talk to the port (sending and receiving) but
> without anything result. Even when setting RTS on sending, there's no
> signal.
> Does anyone has any suggestion on what we could do wrong?
>
> Kind regards,
>
> wimpunk.
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|