Just extract the tarball to (e.g.) /root. See page 35 of the
linuxarm-guide-rev2.2 for a tutorial.
The problem I have is an error message on the SBC like:
./hello: 1: Syntax error: newline unexpected
I've tried to make many small adaptations to the original hello.c, but
even without empty lines I got this error. :(
Anyone an idea?
--- In ts-7000%40yahoogroups.com, "Don W. Carr" <> wrote:
>
> The cross tools, as far as I know, are only compiled for Windows (using
> cygwin), or Linux, just about any kernel works. Since OSX is based
on a unix
> kernel, it should not be a problem to compile the cross tools for
the Mac,
> but somebody would have to do that. Don.
>
> On 5/21/07, cingospet <> wrote:
> >
> > I downloaded the GCC4.0.1 crosstools and am puzzled about how to
install
> > and use them.
> > There is no information or hints on installing/configuring. I
would like
> > to use a PCC Mac as
> > the development platform.
> >
> > Any clues on where to go to install the cross compiler?
> >
> > Craig
> >
> >
> >
>
>
>
> --
> Dr. Don W. Carr
> J. G. Montenegro 2258
> Guadalajara, Mexico
> +52-333-630-0704
> +52-333-836-4500 ext 2930
>