Hi,
I am using the adc code off the TS website for reading the ADC and am
using with a 9302 board. I am noticing that when the input voltage
gets to about 1.65, the ADC becomes very unstable - the raw values
ranging around 0x3333 to 0x6666 which is then making the printed
voltage fluctuate a LOT :).
>From the 9301 manual, the adc swaps around to 0 at that voltage, so I
am guessing that maybe there is a calibration issue, however eve with
calibrartion that still doesnt explain why the raw conversion value is
so different.
ALso, the voltages below 1.65 print ok, and are ok above (approx) 1.74 V.
Any ideas?
------------------------ Yahoo! Groups Sponsor --------------------~-->
Check out the new improvements in Yahoo! Groups email.
http://us.click.yahoo.com/4It09A/fOaOAA/yQLSAA/CFFolB/TM
--------------------------------------------------------------------~->
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|