--- In "wimpunk" <> wrote:
>
> --- In Eddie Dawydiuk <eddie@> wrote:
> >
> > Hello,
> >
> > >>> I'm pretty sorry to report, but we did removed the JP3.
> > >>
> > >> So JP3 is removed and the board is still going to low power mode
> as soon
> > >> as you remove the power?
> > >>
> > >> //Eddie
> > >>
> > >
> > > As far as I can see, the board just stops working. After
putting back
> > > the power, the board reboots.
> >
> > When you are charging the board did you specify the sleep command?
> > If not what command did you enter to charge the batteries? FYI
> > you can put a jumper on the proper pins of the ISP header to wake
> > the bat3 from sleep mode, this is documented in the TS-BAT3 manual.
> > http://www.embeddedarm.com/Manuals/ts-bat3-info.txt
> >
> > //Eddie
> >
>
> As I wrote in my original post, I started bat3 this way:
>
> bat3 --on 300 --off 10 --shutdown 30 --pwm1 1 --pwm2 1 --charge 400 &
>
> I see the led blinking correctly but the board doesn't power the PC104
> bus when removing the 24V power.
>
> Do I have to change the options specified?
>
> wimpunk.
>
Eddie,
I got my board working on batteries. After putting a jumper on the
proper pins of the ISP header, the batteryboard woke up and almost
works as expected: after removing the power, it powers the bus with
the batteries.
Unfortunatly, there's still a problem. The system shuts down after 30
seconds because of the shutdown command which is pretty correct but we
expected to get the board back up and running after putting back the
power source.
Any ideas what we (still) do wrong?
Thanks for the help,
wimpunk.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|