--- In Eddie Dawydiuk <> wrote:
>
> Hello,
>
> >>> I'm pretty sorry to report, but we did removed the JP3.
> >>
> >> So JP3 is removed and the board is still going to low power mode
as soon
> >> as you remove the power?
> >>
> >> //Eddie
> >>
> >
> > As far as I can see, the board just stops working. After putting back
> > the power, the board reboots.
>
> When you are charging the board did you specify the sleep command?
> If not what command did you enter to charge the batteries? FYI
> you can put a jumper on the proper pins of the ISP header to wake
> the bat3 from sleep mode, this is documented in the TS-BAT3 manual.
> http://www.embeddedarm.com/Manuals/ts-bat3-info.txt
>
> //Eddie
>
As I wrote in my original post, I started bat3 this way:
bat3 --on 300 --off 10 --shutdown 30 --pwm1 1 --pwm2 1 --charge 400 &
I see the led blinking correctly but the board doesn't power the PC104
bus when removing the 24V power.
Do I have to change the options specified?
wimpunk.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|