Hello,
> i install the module cs89x0.o
> and then,
>
> $ifconfig eth0 down
> $ifconfig eth1 down
> $ifconfig eth1 up
>> eth1: using half-duplex 100Base-T (RJ-45)
> $ifconfig -a
>> eth1 Link encap:Ethernet HWaddr 00:D0:69:40:55:47
>> inet addr:192.168.0.51 Bcast:192.168.0.255 Mask
> ..........
>> Interupt:33 Base adress: 0x300
> ..........
>> lo .......
> so i have eth1 up and only eth1 up....
>
> then i:
> $ping 192.168.0.5
>> NETDEV WATCHDOG: eth1: transmit timed out
>> NETDEV WATCHDOG: eth1: transmit timed out
>> NETDEV WATCHDOG: eth1: transmit timed out
>> NETDEV WATCHDOG: eth1: transmit timed out
>> NETDEV WATCHDOG: eth1: transmit timed out
> .....
Yesterday we talked on the phone and found the TS-ETH10 didn't have
an IRQ. The reason the board didn't have an IRQ was because there was no
jumper installed on any of the IRQ pins. I suggested you add a jumper to
assign the TS-ETH10 IRQ 5, 6, or 7.
This message was probably sent before our phone conversation, but I
thought I'd post this so it might help out other users with the same
problem. If you are still having problems please let me know.
//Eddie
> --- In "Eddie Dawydiuk" <> wrote:
>>
>> Hello,
>>
>>> I get these messages to pop up when trying to use the 104 card
>>> NETDEV WATCHDOG: eth1: transmit timed out
>>
>> Please provide the output of dmesg after you see this error.
> Please tell
>> us what you were doing prior to this error.
>>
>> //Eddie
>>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|