On Tue, 3 Oct 2006, jhochman2 wrote:
> Jim - first off, thanks for your help on this screwy problem. I'm starting to
> think I just have
> bad media or CF hardware. fdisk doesn't report anything. Attached is my dmesg
> and the
> results of running a few commands (same results w/ CF card in or out). Any
> other ideas or
> do you think I should contact TS?
The obvious thing to do is check the CFDisk on another computer.
On another linux computer check what fdisk gives. If it's the same
then try another cfdisk.
> ****************
>
> >> TS-BOOTROM, Rev 1.08 - built 10:44:37, May 26 2006
> >> Copyright (C) 2006, Technologic Systems
> >> TS-7200: Rev E0 CPU, Rev C PLD, 32MB SDRAM, options ( RS485 )
>
> +No devices on IDE controller 0
> Ethernet eth0: MAC address 00:d0:69:40:53:98
> IP: 192.168.0.50/255.255.255.0, Gateway: 192.168.0.11
> Default server: 192.168.0.11
>
> RedBoot(tm) bootstrap and debug environment [ROMRAM]
> Non-certified release, version current-TS_5 - built 11:24:54, Jun 7 2006
>
> Platform: TS-7200 Board (ARM920T) Rev A
> Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.
>
> RAM: 0x00000000-0x02000000, [0x00044f88-0x01fdd000] available
> FLASH: 0x60000000 - 0x60800000, 64 blocks of 0x00020000 bytes each.
> == Executing boot script in 0.100 seconds - enter ^C to abort
> RedBoot> fis load vmlinux
> RedBoot> exec -c "console=ttyAM0,115200 root=/dev/mtdblock1"
> Using base address 0x00218000 and length 0x000c0000
> Linux version 2.4.26-ts11 (gcc version 3.3.4) #215 Thu
> Jun 8
> 14:30:17 MST
> 2006
> CPU: Arm920Tid(wb) revision 0
> Machine: ep9301
> On node 0 totalpages: 2048
> zone(0): 2048 pages.
> zone(1): 0 pages.
> zone(2): 0 pages.
> On node 1 totalpages: 2048
> zone(0): 2048 pages.
> zone(1): 0 pages.
> zone(2): 0 pages.
> On node 4 totalpages: 2048
> zone(0): 2048 pages.
> zone(1): 0 pages.
> zone(2): 0 pages.
> On node 5 totalpages: 2048
> zone(0): 2048 pages.
> zone(1): 0 pages.
> zone(2): 0 pages.
> Kernel command line: console=ttyAM0,115200 root=/dev/mtdblock1
> Console: colour dummy device 80x30
> Calibrating delay loop... 99.94 BogoMIPS
> Memory: 8MB 8MB 8MB 8MB = 32MB total
> Memory: 28500KB available (1320K code, 350K data, 72K init)
> Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
> Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
> Mount cache hash table entries: 512 (order: 0, 4096 bytes)
> Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)
> Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
> CPU: Testing write buffer: pass
> POSIX conformance testing by UNIFIX
> Linux NET4.0 for Linux 2.4
> Based upon Swansea University Computer Society NET3.039
> Initializing RT netlink socket
> Starting kswapd
> devfs: v1.12c (20020818) Richard Gooch
> devfs: boot_options: 0x1
> JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc.
> ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA
> ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA
> ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA
> pty: 1024 Unix98 ptys configured
> Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ enabled
> rtc: no TS-5620 RTC detected.
> ep93xx_eth() version: ep93xx_eth.c: V1.0 09/04/2003 Cirrus Logic
> Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
> ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
> Technologic Systems TS-7XXX IDE initialization - driver version 1.3, 6/21/04.
> TS-7200 flash: Found 1 x16 devices at 0x0 in 16-bit bank
> Intel/Sharp Extended Query Table at 0x0031
> Using buffer write method
> cfi_cmdset_0001: Erase suspend on write enabled
> Creating 3 MTD partitions on "TS-7200 flash":
> 0x00000000-0x00020000 : "TS-BOOTROM"
> 0x00020000-0x00620000 : "Linux"
> 0x00620000-0x00800000 : "RedBoot"
> NET4: Linux TCP/IP 1.0 for NET4.0
> IP Protocols: ICMP, UDP, TCP, IGMP
> IP: routing cache hash table of 512 buckets, 4Kbytes
> TCP: Hash tables configured (established 2048 bind 4096)
> NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
> NetWinder Floating Point Emulator V0.97 (double precision)
> VFS: Mounted root (jffs2 filesystem).
> Mounted devfs on /dev
> Freeing init memory: 72K
> INIT: version 2.85-ts1.00 booting
>
> http://www.embeddedarm.com
> email:
>
> devfsd v1.3.25 started for /dev
> now mounting /proc
> mounting local filesystems (in fstab)
> sdcard0: Technologic Systems SD card controller, address 0x13000000
> sdcard0: no SD card option present on this board
> TS-UART/7260 did not detect a TS-7260 board
> INIT: Entering runlevel: 3
> Setting hostname....
> Bringing up interface eth0..
> Bringing up interface lo..
> setting kernel IP routing tables
> Starting portmap...
> Starting INETD...
> Starting telnetd...
> Starting apache.../www/apache/bin/apachectl start: httpd started
>
> Technologic Systems TS-LINUX/arm 7.0
> ts7200 login: root
> login[79]: root login on `ttyAM0'
>
>
> BusyBox v1.00-rc2 (2004.08.05-21:44+0000) Built-in shell (ash)
> Enter 'help' for a list of built-in commands.
>
> $ ls /dev/
> console fd mem ptmx stderr ttyAM1 zero
> cuaam0 full mtd pts stdin ttyAM2
> cuaam1 ide mtdblock pty stdout urandom
> cuaam2 initctl null random tty vc
> fb kmem port root ttyAM0 vcc
> $ ls /dev/ide/
> $ fdisk -l /dev/ide/host0/bus0/target0/lun0/disc
> $
>
>
>
>
>
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|