| To: | |
|---|---|
| Subject: | Re: [ts-7000] SER4 Boards - Two (2) with the TS7200 |
| From: | "Eddie Dawydiuk" <> |
| Date: | Fri, 7 Apr 2006 17:07:59 -0700 (MST) |
Hello,
> The current kernel only supports 4 ports (refer #define RS_TABLE_SIZE
> 4 in the ../include/asm-arm/arch/serial.h file) I have modify this to
> 8 and updated the STD_SERIAL_PORT_DEFNS initialisation. The kernel
> boots ok and the 'setserial' reports fine. However, when I try to use
> any of the ports they either work very slowly or simply just hang the
> board.
Typically this means that the interrupts are not setup properly. Have
you verified this with the setserial command.
ISA IRQ 6 = Linux IRQ 33
ISA IRQ 7 = Linux IRQ 40
//Eddie
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [ts-7000] Re: New Product: TS-7300, Eddie Dawydiuk |
|---|---|
| Next by Date: | Re: [ts-7000] pointers to accessing sd cards on a ts-7260, Eddie Dawydiuk |
| Previous by Thread: | Re: [ts-7000] Re: New Product: TS-7300, Eddie Dawydiuk |
| Next by Thread: | [ts-7000] Re: SER4 Boards - Two (2) with the TS7200, Yan Seiner |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU