[ts-7000] Re: SER4 Boards - Two (2) with the TS7200

["amalgamatedsystems" <>]

Hi,

Thanks Eddie.  Yes I have confirmed the IRQs.  I have the first SER4
board set to a single IRQ 6 and the second SER4 board set to a single
IRQ 7.  Any more clues?  I believe the SER4 boards can work with a
single IRQ.

Thanks,

Clive


--- In  "Eddie Dawydiuk" <> wrote:
>
> Hello,
> 
> > The current kernel only supports 4 ports (refer #define RS_TABLE_SIZE
> > 4 in the ../include/asm-arm/arch/serial.h file)  I have modify this to
> > 8 and updated the STD_SERIAL_PORT_DEFNS initialisation.  The kernel
> > boots ok and the 'setserial' reports fine.  However, when I try to use
> > any of the ports they either work very slowly or simply just hang the
> > board.
> 
> Typically this means that the interrupts are not setup properly. Have
> you verified this with the setserial command.
> 
> ISA IRQ 6 = Linux IRQ 33
> ISA IRQ 7 = Linux IRQ 40
> 
> //Eddie
>







 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/