I have a requirement for writing some code that:
1) configures the ts-7000 via web
2) initializes a wifi device
I can write the code, but I'd like to share it, and or use someone
elses. Is anyone else interested in this ?
Dave
On 5-Feb-06, at 12:03 PM, Jim Jackson wrote:
>
>
> On Sun, 5 Feb 2006, sumit_shrivastava09 wrote:
>
>> hi,
>> I have one TS7250 bord .now I am supposed to port one
>> application to
>> this bord sothat i becomes one embedded system (this is for demo
>> purpose , like I was asked to make it router but it is not possible
>> because it has only one ethernet card , is it possible ) but I am
>> not
>> getting which application should I choose . can anybdoy suggest me
>> this.
>
> There are several possibilities....
>
> It is possible to have a "router on a stick" :-)
> It is possible to configure 2 or more different network addresses
> on the
> same interface and route between them. There are reasons you might do
> this.
>
> In similar vein, you could setup a VPN tunnel to a VPN server or a PPP
> over Ethernet connection and do routing.
>
> You can get USB ethernet or WIFI adapters and do routing.
>
> You could use one of the serial ports as a PPP over serial
> interface and
> route.
>
> You could use it to setup an 6to4 router (IPv6 to IPv4 encapsulation
> tunnel - see rfc3056) and do IPv6 routing!
>
> The possibilities are endless, if you are simply wanting some sort
> of demo
> project.
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|