Re: [ts-7000] Re: [ts-7250] 5 internal (EP9302) ADC

["Eddie Dawydiuk" <>]

Hi Chris,

> I try using the example code posted in the files section for the ts-
> 7250 ADC, but it doesn't seem to work. All of my samples are 0 when I
> connect the channels to ~2.8V. I am assuming that the channels are
> those 10 pins (not the 16 pins) labeled A/D.
> Do I need to do anything
> else to get it to work? Am I using the right pins?


The 10 pin header labeled A/D is the correct header. The pinout is below

ADC
Channel |  Pin #
----------------------
0       |   1
1       |   3
2       |   5
3       |   7
4       |   9

We recently started storing board specific calibration values to the
eeprom. The sample code assumed that your board had these calibration
values.... I just updated the code so it will work with or without these
calibration values.

//Eddie







 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/