I try using the example code posted in the files section for the ts-
7250 ADC, but it doesn't seem to work. All of my samples are 0 when I
connect the channels to ~2.8V. I am assuming that the channels are
those 10 pins (not the 16 pins) labeled A/D. Do I need to do anything
else to get it to work? Am I using the right pins?
--- In "Eddie Dawydiuk" <> wrote:
> > I am trying to use the ts-7250 internal ADC from the EP9302 chip.
The
> > manual and example codes on the newsgroup only talk about the 8-
> > channels ADC using the MAX197. Are the A/D and control registers the
> > same for 8-channels as for the 5 internal channels? Any example
code or
> > help is much appreciated.
>
> I have justed posted some example code in the files section. We
recently
> started to store board specific calibration values for each AtoD
channel.
> This code assumes your board has these calibration values and will use
> them when calculating the voltage...
>
> //Eddie
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|